[time-nuts] 10811 Repair (was warmup / bad batch)

Jason Rabel jason at extremeoverclocking.com
Mon Jan 22 18:15:31 EST 2007


Okay, so I've partially disassembled my 10811, I have checked most of the
points in the manual and everything appears okay.

A couple questions though. There are a pair of black wires running from the
top PCB down under the board below it (I haven't removed that board yet to
see what is underneath), what are those wires for? I probed them and there
doesn't appear to be any power?

Second, the crystal has a red, green, and blue wire. I've probed all 3 of
those and nothing. I would of expected one to be power, unless that is what
the above mentioned black wires are for.

About to call it a day. tomorrow I'll finish disassembling and see what all
goes where.

Jason




More information about the time-nuts mailing list