[time-nuts] ACE-III GPS receivers
Didier Juges
didier at cox.net
Sat Jan 27 23:11:38 EST 2007
I found them in the paper catalog, it's page 877 (the web site says page
868, but that's not it).
At $8 for one cable good for 2 receivers, that's all I need.
Thanks
Didier KO4BB
jmfranke wrote:
> I purchased five of the twenty pin twelve inch cables and cut them in half
> to have ten pigtailed connectors. Of course, if you want the red edge to
> mark the location of pin one, five have the cable coming directly off the
> board and the other five have the ribbon cable passing back over the Jupiter
> board. I tried soldering to the pins of a bare connector, but it failed
> after a couple insertions. It was on a homemade test rig. I terminate the
> ribbon cable at a barrier strip. I am too old for this microscopic surgery.
>
> John
More information about the time-nuts
mailing list