[time-nuts] Oncore VP problem
kirbybq at bellsouth.net
Thu Jul 19 07:29:01 EDT 2007
In the TAC32 documentation, you will read about Mouse data and GPS data !
Theres a command line switch to run that should resolve it (NoSerialMice
or something to that efect)....
GandalfG8 at aol.com wrote:
> ); SAEximRunCond expanded to false
> Errors-To: time-nuts-bounces+kirbybq=bellsouth.net+kirbybq=bellsouth.net at febo.com
> X-Spam: [F=0.0149253731; S=0.010(2007071801); MH=0.500(2007071904); R=0.600(s0/n0)]
> X-MAIL-FROM: <time-nuts-bounces+kirbybq=bellsouth.net at febo.com>
> X-SOURCE-IP: [(unknown)]
> X-MxL-Spam-Verdict: No
> In a message dated 19/07/2007 02:44:42 GMT Daylight Time, tom.k3io at gmail.com
> My suggestion is that you pick up a free evaluation copy of Rick
> Hambly's TAC32 software at http://cnssys.com/cnsclock/Tac32Software.html
> . TAC32 knows all the quirks & options that ever existed in a Motorola
> receiver, going all the way back to the Rev.3 PVT6. Then if you find it
> useful, a legal copy can be purchased from Rick, or at members discount
> from TAPR (http://www.tapr.org/gps_tac32.html).
> Hi Tom
> Many thanks for the suggestion.
> You may have seen my subsequent post in which I commented that I had tried
> TAC32 without solving my problem, only to find the kit was working ok but with
> an incorrectly labelled connector.
> TAC32 does look useful though so I'll check it over more thoroughly later.
> One "interesting" side effect......
> Some time after shutting down TAC32 last night, but with the Oncore still
> connected to the serial port and outputting data, my PS2 connected mouse started
> misbehaving, with the pointer jumping all over the place then settling down
> for a while before repeating the performance.
> It didn't occur to me at first that the incoming serial data might have
> anything to do with it until it started again this morning and I eventually
> stopped it by disconnecting the serial lead from the receiver.
> Whilst I can't say for sure that running TAC32 was what caused it, it's not
> something I've ever seen in the past nor previously this past few days after
> running WinOncore.
> I'll check later to see if the port shut down properly and also take a look
> at the Oncore message stream, perhaps TAC32 may have changed something there
> as part of its auto setup routine?
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the time-nuts