[time-nuts] Parallel voltage regulators
Don Collie
donmer at woosh.co.nz
Thu Oct 25 00:15:45 EDT 2007
Hi Tom,
If you really want to regulate the oven`s supply voltage, my National
Voltage Regulator handbook shows that the LM317T will supply over 2 Amps,
with an input/output differential of between 5, and 12.5 Volts. A single one
of these should do the job OK.
Cheers!,.................................Don Collie jnr.
----- Original Message -----
From: "Tom Clifton" <kc0vsj at yahoo.com>
To: <time-nuts at febo.com>
Sent: Thursday, October 25, 2007 12:33 PM
Subject: [time-nuts] Parallel voltage regulators
> ); SAEximRunCond expanded to false
> Errors-To: time-nuts-bounces+donmer=woosh.co.nz at febo.com RETRY
>
> A question for those that might know (or have an
> opinion)... I have in hand an LPRO rubidium reference
> that requires 1.7 amps at 24 volts while the oven
> warms, dropping to 500ma while it runs.
>
> Can I parallel three or four 7824 TO220 style 1 amp
> regulators with a quarter ohm half watt equalizing
> resistor on the output of each one?
>
> At maximum load there would be a quarter volt drop
> across the resistors and the LPRO is stated to be ok
> running on 16 to 32 volts.
>
> Tom
>
> __________________________________________________
> Do You Yahoo!?
> Tired of spam? Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the time-nuts
mailing list