[time-nuts] Soundcard sampling Re: Picking a good HP 10811

Bruce Griffiths bruce.griffiths at xtra.co.nz
Tue Dec 2 19:28:18 UTC 2008


Lux, James P wrote:
>
> On 12/1/08 10:58 PM, "Bruce Griffiths" <bruce.griffiths at xtra.co.nz> wrote:
>
>
>   
>> Thus it may well be worthwhile doing this as one then (in principle)
>> only needs 3 mixers (plus 3 simultaneously sampled sound card input
>> channels) and no offset source, however the maximum achievable offset
>> will probably result in beat frequencies that are a little too low for a
>> sound card ADC.
>>     
>
> Most sound cards roll off below around 10-20 Hz, or, at least, you're
> starting to get into the roll off filter characteristic where the phase is
> changing rapidly.
>
> Re: "simultaneously sampled"...  I would assume that sample jitter here
> affects the measurement.  Granted, one can do a fit of many samples to a
> sine wave, and get a sqrt(N) improvement (if it's random jitter, and not
> systematic), but what's a typical spec for channel/channel jitter on a sound
> card?  Or, more properly, if you're measuring an Allan deviation of, say,
> 1E-15 over 100 seconds for a couple 10MHz sources beaten down to, say, 100
> Hz or thereabouts.. How good does it need to be?
>
>
>   
Being a consumer item the sampling jitter of a sound card isn't usually
specified however 100ps jitter should have a very noticeable effect on
the performance of a high end 24 bit sound card.

Bruce



More information about the time-nuts mailing list