[time-nuts] LPRO 101 ADJUSTMENT
Scott Mace
smace at intt.net
Fri Jul 25 19:15:06 EDT 2008
Both methods work well. Be sure the unit is mounted to some sort of heatsink,chassis, etc.
I'm using a Fury GPS receiver to drive the EFC on an LPRO-101.
You won't get much range out of either adjustment. Leave it powered
on for a couple of hours before trying to adjust it. I usually set the trim pot in the
middle of it's range and use the EFC pin. I think it's a 28 or 30 turn pot. EFC
is 0-5v. The unit will self-bias to around 2.5v if the EFC pin is open.
Scott
jshank wrote:
> Hi,
>
> I recently acquired a LPRO 101 Rubidium Oscillator. After reading the
> manual I see that there are two ways to adjust the frequency 1) using and
> adjusting screw on the unit and 2) using the External C-field control signal
> at pin J1-7. Has anyone experimented with either method and if so what
> method was preferred?
>
> Jeff
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
>
More information about the time-nuts
mailing list