[time-nuts] LPRO-101

Scott Mace smace at intt.net
Mon Jan 12 05:31:27 UTC 2009


I've seen Datum clocks of various sorts with these just mounted to the 
chassis, no special heatsink, especially the 1RU units.

	Scott

On 01/11/2009 10:13 PM, Glenn Little WB4UIV wrote:
> I have a LPRO-101. Before I power it up, I have been advised to use a heatsink.
> How large of a heatsink do I need?
> I found an extruded heatsink in the junk box.
> This heatsink has fins about 0.50 inches high.
> The width is 2.375 inches wide.
> It is 8.125 inches long.
> I plan to cut this heatsink in half giving me two 4.0 inch pieced.
> I plan to bolt each piece to the bottom of the LPRO-101, using the
> six mounting holes, three per heatsink.
> Would this be sufficient heatsink?
>
> Thanks in advance.
> 73
> Glenn
> WB4UIV
>
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
>



More information about the time-nuts mailing list