[time-nuts] Stable Z38XX
Ulrich Bangert
df6jb at ulrich-bangert.de
Sat Jul 11 08:44:15 UTC 2009
Guys,
I just uploaded a new version that features an additional sat c/n chart.
Enjoy
Ulrich Bangert
> -----Ursprungliche Nachricht-----
> Von: time-nuts-bounces at febo.com
> [mailto:time-nuts-bounces at febo.com] Im Auftrag von Ulrich Bangert
> Gesendet: Samstag, 11. Juli 2009 09:47
> An: 'Discussion of precise time and frequency measurement'
> Betreff: Re: [time-nuts] Stable Z38XX
>
>
> Hi Said,
>
> not necessary to supply you with a list: Just start the
> software and open the debug window. You will see all serial
> communication action. With no device connected just the
> commands will appeear one below the other. You can use the
> "window hold" option of the debug window to defeat the scrolling.
>
> There is also a second option: If you supply ME a list of
> commands that your devices understand then I can detect the
> device type by the answer to *IDN? and ask the devices just
> what they understand and leave everything else out. That is
> the stategy that the software already uses to cover the
> Z3801/5/15 and the GCRU.
>
> Best regards
> Ulrich
>
> > -----Ursprungliche Nachricht-----
> > Von: time-nuts-bounces at febo.com
> > [mailto:time-nuts-bounces at febo.com] Im Auftrag von SAIDJACK at aol.com
> > Gesendet: Freitag, 10. Juli 2009 20:23
> > An: time-nuts at febo.com
> > Betreff: Re: [time-nuts] Stable Z38XX
> >
> >
> > Hi Ulrich,
> >
> > any chance you could send me a list of commands you utility
> > uses as a
> > minimum command-set so I can cross-check against our
> > Fury/FireFly GPSDO's?
> >
> > There are lots of folks on this list that have our units, and
> > it would be
> > great if we could get it up and running for our interface as
> > an alternative
> > to GPSCon.
> >
> > Thanks,
> > Said
> >
> >
> > In a message dated 7/10/2009 07:17:31 Pacific Daylight Time,
> > df6jb at ulrich-bangert.de writes:
> >
> > Guys,
> >
> > after a lot of help coming from Australia (thank you Hal and
> > Kit) there is
> > a
> > stable version of my Z38XX utility available. It handles the
> > Z3801, the Z3805, the Z3815 and the GCRU.
> >
> > It is available from the usual place. Enjoy!
> >
> > Ulrich Bangert
> > www.ulrich-bangert.de
> > Ortholzer Weg 1
> > 27243 Gross Ippener
> >
> >
> > _______________________________________________
> > time-nuts mailing list -- time-nuts at febo.com
> > To unsubscribe, go to
> > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> > and follow the instructions there.
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the time-nuts
mailing list