[time-nuts] Trimble Thunderbolt setup optimization and adding a10811 OCXO
SAIDJACK at aol.com
SAIDJACK at aol.com
Tue Jul 14 01:11:06 UTC 2009
Hi Don,
to disable the Fury (or FireFly) GPS receiver from disciplining the unit,
send the command:
sync:sour:mode ext
That will switch the unit to external 1PPS input, and thus make it go into
holdover if there is nothing connected to the external 1PPS input.
Bye,
Said
In a message dated 7/13/2009 13:16:01 Pacific Daylight Time,
true-cal at swbell.net writes:
I have better luck disabling desciplining on the TBolt or disconnecting
the antenna on the Fury (no command to disable that I have found) when I
need to do a Tau 0.1-10 sec. low jitter measurement.
Regards...
Don
More information about the time-nuts
mailing list