[time-nuts] 5370A

[Bruce Griffiths]

Joe

Just be careful no to break the plastic handles off the boards.
The board retention force can be quite high.

Bruce

Joseph Gray wrote:
> Bruce,
>
> I have a 100MHz scope, DVM, frequency counter, signal generator, etc.
> Sorry, no spec an. I wish I had one.
>
> The first problem is that it fails the first performance test. Instead
> of 100nS, I get about 10nS and that slowly increases to about 12nS.
> This is with the unit already warmed up and it is repeatable. I
> checked the internal reference output and it is very close to 10MHz,
> so that isn't the problem.
>
> Before I go any further, I think I'll open it up reseat all the
> boards. It couldn't hurt.
>
> Joe
>
> On Fri, Oct 9, 2009 at 11:51 PM, Bruce Griffiths
> <bruce.griffiths at xtra.co.nz> wrote:
>   
>> Joseph Gray wrote:
>>     
>>> I just got a 5370A locally and am going through the performance
>>> checks. Things are not as they should be. Is there someone who knows
>>> this unit intimately who would be willing to help me off list?
>>>
>>> Joe Gray
>>> KA5ZEC
>>>
>>>
>>>       
>> Joe
>>
>> What do you have in the way of test gear?
>> A 100+MHz scope would be useful as well as a spectrum analyser.
>>
>> Bruce
>>
>>
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>>
>>
>>     
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
>