[time-nuts] No 1 PPS output on a Tbolt

Bob Camp lists at cq.nu
Sun Feb 7 16:26:16 UTC 2010


Hi

The 5345 should see it if it's set to 50 ohm termination and DC coupling. A 
sweep of the trigger from about 1.5 to 3.5 volts should show it there over 
most of the sweep.

Bob

--------------------------------------------------
From: "SAL CORNACCHIA" <salccor at rogers.com>
Sent: Sunday, February 07, 2010 11:06 AM
To: "Discussion of precise time and frequency measurement" 
<time-nuts at febo.com>
Subject: Re: [time-nuts] No 1 PPS output on a Tbolt

> Oscilloscope and 5345A Counter, the Tbolt software shows all green.
>  Best regards,
> Sal C. Cornacchia
> Electronic RF Microwave Engineer (Ret.)
>
>
>
>
>
>
>
> ________________________________
> From: "Stan, W1LE" <stanw1le at verizon.net>
> To: Discussion of precise time and frequency measurement 
> <time-nuts at febo.com>
> Sent: Sun, February 7, 2010 10:47:42 AM
> Subject: Re: [time-nuts] No 1 PPS output on a Tbolt
>
> Hello Sal,
>
> What are you monitoring the PPS output with ??
>
> It is a short duration pulse.
>
> What does the TboltMON software (available at the trimble website) show ?
>
> What does Lady Heather indicate ?
> (She is just waiting to massage your numbers.)
>
> Stan, W1LE
>
>
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to 
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to 
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
> 



More information about the time-nuts mailing list