[time-nuts] 4 KV Power Supply Recommendations

J. L. Trantham jltran at worldnet.att.net
Sun Jan 17 03:32:02 UTC 2010


Sorry, TIA.

I was monitoring pin 4, not pin 3.  Pin 3 is -1.129 VDC which would imply a
current of 112.9 uA.

I will watch overnight and see what happens.

Any thoughts appreciated.

Joe

-----Original Message-----
From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
Behalf Of J. L. Trantham
Sent: Saturday, January 16, 2010 9:02 PM
To: time-nuts at febo.com
Subject: [time-nuts] 4 KV Power Supply Recommendations


I have a 5061A That I am trying to bring on line and it pegs the Ion Pump I
meter reading.  Measuring the voltage at pin 3 of the +3500V power supply, I
get -0.275 VDC.  This is across a 10K resistor and suggests that CS tube
current is 27.5 uA.  The voltage from the power supply with the tube
connected is 2050 VDC and around 3100 VDC with the tube disconnected.

It is recommended to connect the tube to an external 3500 VDC supply capable
of 5 mA and let it run to see if the current will come down.  Having watched
the voltage on pin 3 during the day, it has come down to -0.269 VDC and the
voltage with the tube connected has gone up to around 2075 VDC.

Any thoughts on a source for an external HV power supply for this
application?

Any thoughts on whether to just let it sit for a week or two to see if it
'pumps down'?

Any thoughts on other things to try?

Thanks,

Joe


_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.




More information about the time-nuts mailing list