[time-nuts] Motorola GPS Z3801A

Robert Benward rbenward at verizon.net
Wed Jun 2 01:17:18 UTC 2010


Hi Rex,
One more question:  I understand some of the Z3801A were equipped with the Furuno 16ch GPS. Do you know the model of 
this GPS, or was it only for the Z3805A or the Z3816A?

Thanks,
Bob


----- Original Message ----- 
From: "Rex" <rexa at sonic.net>
To: "Discussion of precise time and frequency measurement" <time-nuts at febo.com>
Sent: Tuesday, June 01, 2010 8:28 PM
Subject: Re: [time-nuts] Motorola GPS Z3801A


> Robert Benward wrote:
>> Hi,
>> Does anyone have the pinouts for the Motorola GPS within the Z3801A?  It's a ten pin header and I would like to 
>> intercept the data stream to see if it's working.  Also, I read about some of the Motorolas putting out binary data, 
>> not NEMA protocol.
>>
>> Thanks,
>> Bob
>>
> The Oncore interface diagram on Didier's page should be enough to see which pins are which:
> http://www.ko4bb.com/cgi-bin/manuals.pl?dir=05%29_GPS_Timing
>
> For the details, here's a link to a nice clean Oncore manual:
> http://gpsd.berlios.de/vendor-docs/motorola/
>
> Chapter 6 of that manual is a description of the Oncore commands that are used by these receivers. Yes, it is a 
> mixture of ASCII commands with binary data.
>
> I forget which receiver(s) the Z3801A used. My Z3816a has a UT+ but it is a little more recent than the 3801's. 
> Someone here, no doubt, remembers.
>
> A few years back there were a bunch of posts to this list with reference documents for the various Oncores that HP or 
> Symmetricom used in the timing receivers. Lots of detail of firmware versions and differences between the Oncore 
> receivers. I don't have a link now. Maybe others do.
>
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there. 




More information about the time-nuts mailing list