No subject

10 and divide. I use the 10 mc straight out buffer it and distribute it
around on 75 ohm cable.
You could actually I might guess just bypass the pals and drive into the
mmics as outputs.

On Mon, Oct 11, 2010 at 7:12 PM, Rex <rexa at sonic.net> wrote:

>  I haven't seen the XO version (I have a similar Rb) but they no doubt make
> 15 MHz from either a 5 or 10 MHz XO. My guess is that it is 10 MHz like the
> Rb. If it was me, I'd dismember the thing and either use existing (possible)
> 5 or divide the (likely) 10 by 2 and have fewer steps in your chain.
>
>
>
> On 10/11/2010 4:00 PM, Richard W. Solomon wrote:
>
>> I would find 5 MHz more useful than 15 MHz. Can anyone
>> recommend a divide-by-3 device I could use. I could add
>> another connector to the front and just stick it inside.
>>
>> Thanks, Dick, W1KSZ
>>
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to
>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>>
>>
>>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>