[time-nuts] pts 160 power problem

[J. Forster]

That depends on the phase of the moon and your religion.

Sometimes low-ESR aluminum; other times good Tantalums (150D or CS-13s)

No two people agree on this issue.

-John

==============


> thanks everyone.
>
> i found a cache of tantalum caps in the output amp module.  also, there
> isn't any output any more.
> struggling to get all those @#@ screws out so i can get to them.
>
> should i find new tantalum caps, or is there a better substitute?
>
> dave
>
> On Fri, Feb 25, 2011 at 11:29 AM, <GandalfG8 at aol.com> wrote:
>
>>
>> In a message dated 25/02/2011 17:13:01 GMT Standard Time,
>> dave.mallery at gmail.com writes:
>>
>> i tried  another more robust 5v supply, but that goes to 4.5v and ng
>> output.
>>
>> i  removed each of the plug-in decades, one at a time, looking for the
>> guilty
>> one.  no joy.  i also removed the left rear module (uses  5v).  the
>> other
>> two
>> modules only use 12v. which is fine.
>>
>> has  anyone been here before?  could it be a problem in the backplane (a
>> work
>> of art, btw)?
>>
>>
>>
>> ---------------
>> Hi Dave
>>
>>
>> I've used quite a few of these and have never yet experienced an  actual
>> component failure, obviously not saying it can't happen just that  once
>> sorted
>> yours should remain pretty reliable.
>>
>>
>> As John already suggested I'd also look for possible fautly tantalums or
>> other capacitors across the supply but would also suggest removing all
>> the
>> modules from the motherboard at the same time before proceeding any
>> furter
>> and checking if the symptoms still persist.
>> I know what you've done has probably eliminated the modules but it
>> would
>> be a shame to tear into the backplane if you just happened to have more
>>  than
>> one faulty module.
>>
>> I did once receive a previously working PTS160 by post that refused to
>> play
>>  and eventually located a very small solder blob, presumably  from
>> inside
>> the associated module, that had dropped into an edge  connector and
>> wedged
>> between a couple of pins, that was fun:-)
>>
>> If you haven't already found it there's a manual for the PT160 on
>> Didier's
>> site.........
>>
>> _http://www.ko4bb.com/cgi-bin/manuals.pl?dir=05%29_GPS_Timing/PTS_
>> (http://www.ko4bb.com/cgi-bin/manuals.pl?dir=05)_GPS_Timing/PTS)
>>
>> regards
>>
>> Nigel
>> GM8PZR
>>
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to
>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>>
>
>
>
> --
> Dave Mallery, K5EN                 (ubuntu linux 10.10)
> HC31 Box 99E;                   Williamsburg,  NM  87942
>
> no gates...
>   no windows!
>     free at last!
>       linux counter #64628 (since 1997)
>
> "People aren't as dumb as Microsoft needs them to be."
> --PJ, May 2007
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
>