[time-nuts] Upgrading TS2100 from TCXO to OCXO
Greg Dowd
GDowd at symmetricom.com
Tue Mar 29 00:28:16 UTC 2011
I think a couple of those bits do correspond to the oscillator type installed but I think you can ignore them. If I remember right, those oscillator bits were only used to calculate the dispersion update for ntp packets when flywheeling through a loss of signal. As far as I recall, you just need to change gain and filter. And the setting for the current d/a value should have been accessible in root tim utils as d2a.
As someone pointed out, the default ovenized for those boxes was the MTI 240 low profile.
-----Original Message-----
From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On Behalf Of Robert Watzlavick
Sent: Sunday, March 27, 2011 3:54 PM
To: Discussion of precise time and frequency measurement
Subject: Re: [time-nuts] Upgrading TS2100 from TCXO to OCXO
If anybody has a TS2100 that came from the factory with an OCXO, can you
telnet into the unit and run the following command?
root eng ee info
This appears to be some sort of factory-configured personality of the
board. My TS2100-GPS unit with a TCXO has an info value of 00000024. A
TS2100-IRIG unit (no GPS) with a TCXO has a value of 00000000. I'm
curious whether any of those bits correspond to the oscillator type or
if all that needs to be changed is the gain.
Thanks,
-Bob
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the time-nuts
mailing list