[time-nuts] ublox chip sets - what GPS device should I buy?
SAIDJACK at aol.com
SAIDJACK at aol.com
Fri Aug 31 19:35:20 UTC 2012
Dave,
that depends on which uBlox the unit supports. There are basically three
different sizes: AMY, LEA, and NEO. They also sell chip-sets, but only to
very large volume customers.
Any of the uBlox-6 will be excellent, the choice will depend on
form-factor, and also if you need a timing-version that supports position-hold mode
(denoted as a -T) or not. Even the uBlox-5 units are already extremely good.
This assumes you can solder the uBlox module onto a PC board inside the
analyzer yourself.
bye,
Said
In a message dated 8/31/2012 12:14:09 Pacific Daylight Time,
david.kirkby at onetel.net writes:
I've bought an Agilent N9923A portable 2 MHz to 6 GHz vector network
analyzer which supports GPS. I assumed it had the GPS bought it, but
later found it it needs a GPS unit with a ublox chip set.
Are there any ones to avoid, or which are good?
Dave
More information about the time-nuts
mailing list