[time-nuts] Morion MV89 output level?

Bob Camp lists at rtty.us
Thu Feb 9 17:20:53 UTC 2012


Hi

I would avoid super heat type approaches. The risk is getting the glass to
metal seals on the base to hot to fast. Normally the can needs more heat
than the base, but not always. A lot depends on just how thick each one is
and what they are made of.

Bob

-----Original Message-----
From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
Behalf Of Stan, W1LE
Sent: Thursday, February 09, 2012 7:47 AM
To: Discussion of precise time and frequency measurement
Subject: Re: [time-nuts] Morion MV89 output level?

Would it be better to apply heat the metal shell or to apply heat the 
bottom part with the I/O pins ?
I would start using a propane gas torch. Heating quickly till I saw the 
solder flow.

Stan, W1LE    Cape Cod


On 2/9/2012 6:04 AM, Azelio Boriani wrote:
> Don't be afraid and open up your MV89. I have done this with many MV201
> without problems.
>
>


_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.




More information about the time-nuts mailing list