[time-nuts] Subs for obsolete chips in pictic
Shawn
shawn at xmtservices.net
Mon Jan 2 19:56:32 UTC 2012
I'll also take 10.
Shawn
Sent from my iPhone
On Dec 29, 2011, at 15:51, "J. L. Trantham" <jltran at att.net> wrote:
> Eric,
>
> If you go for the 100, I'll take 10.
>
> Joe
>
> -----Original Message-----
> From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
> Behalf Of Eric Garner
> Sent: Thursday, December 29, 2011 12:00 PM
> To: Discussion of precise time and frequency measurement
> Subject: Re: [time-nuts] Subs for obsolete chips in pictic
>
> I located a supply of 74AC175PC for $2 USD at qty 100. I still need 2 of
> them to finish off all of my PICTIC II's (I have 3 completed). Are there
> still some available from people willing to part with some? or is there
> enough interest in that I could distribute enough of them to list members
> at cost to make an order worth while?
>
> -Eric
>
> On Mon, Dec 19, 2011 at 10:37 AM, Attila Kinali <attila at kinali.ch> wrote:
>
>> On Mon, 12 Dec 2011 09:42:14 -0800
>> Chris Albertson <albertson.chris at gmail.com> wrote:
>>
>>> Thanks. The findchips.com suggestion was good. Seems the "74AC"
>>> part really is not available but there is a "CD74ACxxx" part that
>>> looks good.
>>
>> The CD at the front just means it's from TI instead someone else.
>> The parts are the same.
>>
>>> The problem is, the PCB is already made so it is hard to adapt the
>>> design to other parts. If I were designing from scratch I'd only
>>> select parts that were stocked in high volume by most distributers
>>
>> Not really. Using SMD parts instead of DIL is easy to do. They have
>> the same pinout, just half the size. So a little bit of glue, a few
>> wires and a steady hand are all that is needed to fit one of those in.
>> Alternatively, there are break out boards from SOP/SSOP/SOIC to DIL
>> (but they cost more than it's worth)
>>
>> Attila Kinali
>>
>> --
>> Why does it take years to find the answers to
>> the questions one should have asked long ago?
>>
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to
>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>>
>
>
>
> --
> --Eric
> _________________________________________
> Eric Garner
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the time-nuts
mailing list