[time-nuts] Trimble Resolution SMT - good/bad/indifferent?

[SAIDJACK at aol.com]

Ok,
 
I figured out that the unit fluke.l sells is running firmware to  emulate 
the Motrola M12+ receiver or similar. So WinOncore 12 does work, and I  can 
get the following receiver ID:
 
COPYRIGHT 2008 Trimble Navigation Ltd.
SFTW P/N # 0000
SOFTWARE VER # 0.03.0
SOFTWARE REV # 00
SOFTWARE DATE  04/27/2009
MODEL #    3011
HDWR P/N # 0000
SERIAL #   20393136
MANUFACTUR DATE  06/05/2009
OPTIONS LIST    0000
 
Does anyone know what the command is to configure this for NMEA or  TSIP?
 
Thanks,
Said
 
 
In a message dated 5/10/2012 12:15:56 Pacific Daylight Time,  
SAIDJACK at aol.com writes:
 
Hi  Holrum,

how do you re-configure the SMT unit? Using Trimble GPS  studio?

Thanks,
Said


In a message dated 5/9/2012 15:17:21  Pacific Daylight Time,  
holrum at hotmail.com writes:

I  have  it running now.  It turns out that the units from fluke.l come  
shipped  with TEP format messages enabled (it outputs @@Cf on power  up).  
You 
have  to re-configure them for TSIP protocol and save  the configuration 
back 
to the  unit.  Hope to have Lady Heather  taking to it.  It does come up 
with  
several of the messages  working.  Sat info is not one of   them.


_______________________________________________
time-nuts  mailing list -- time-nuts at febo.com
To unsubscribe, go to  
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the  instructions there.