[time-nuts] HP Z3805A com port and monitoring questions
Edgardo Molina
xe1xus at amsat.org
Sun Oct 14 16:24:47 UTC 2012
Dear Azelio,
Thank you. I left the receivers running since yesterday and they are still solid lock state. I will measure pin 2 as you kindly stated. I will come back with the results. Thank you for pointing out this test. You are always willing to help!
Kind regards,
Edgardo Molina
Dirección IPTEL
www.iptel.net.mx
T : 55 55 55202444
M : 04455 20501854
Piensa en Bits SA de CV
Información anexa:
CONFIDENCIALIDAD DE INFORMACION
Este mensaje tiene carácter confidencial. Si usted no es el destinarario de este mensaje, le suplicamos se lo notifique al remitente mediante un correo electrónico y que borre el presente mensaje y sus anexos de su computadora sin retener una copia de los mismos. Queda estrictamente prohibido copiar este mensaje o hacer usode el para cualquier propósito o divulgar su en forma parcial o total su contenido. Gracias.
NON-DISCLOSURE OF INFORMATION
This email is strictly confidential and may also be privileged. If you are not the intended recipient please immediately advise the sender by replying to this e-mail and then deleting the message and its attachments from your computer without keeping a copy. It is strictly forbidden to copy it or use it for any purpose or disclose its contents to any third party. Thank you.
On Oct 14, 2012, at 7:47 AM, Azelio Boriani <azelio.boriani at screen.it> wrote:
> Use a multimeter to see if the DB25 pin 2 is -12V, if so you have a
> standard RS232 serial port. Then connect to it, use a USB-RS232 interface
> if necessary, and type SYST:STAT?
> you will see the status page out of the Z3805 (use 9600,N,8,1 for the
> serial settings).
>
> On Sun, Oct 14, 2012 at 4:18 AM, Edgardo Molina <xe1xus at amsat.org> wrote:
>
>> Dear Group,
>>
>> Good evening. I bought two HP Z3805A units a few weeks ago. They were bare
>> units without antenna or power supply. After struggling to find a suitable
>> 24V 3A noise free power supply for each of them, I mounted a couple of
>> Symmetricom antennas and just fired them up.
>>
>> After around 25 minutes, the GPS Lock light lighted up. As the manual for
>> this particular model is unobtainable in several searches through the
>> Internet, I found that the readily available manual for the Z3801A would
>> cover much of the Z3905A operation. I also got a software for monitoring
>> the operation from BD Systems Inc. In Colorado. Now that I am sure both are
>> operating and locked only by looking at the front panel lights, I would
>> like to ask a couple of questions regarding their communication to the PC.
>>
>> 1. Is the DB-25 serial port carrying RS-232 signals? I see the port of the
>> Z380A1 is different: RS-422.
>> 2. If the port is plain RS-232 is it possible to use a Serial to USB
>> adapter? I have heard about the inconsistencies that such an adapter could
>> cause when used with a TBolt. Should I assume this is the same case with
>> the Z3805A?
>> 3. There was once a project for building a TBolt state monitor on a 2 line
>> LCD screen. I own three of those monitors and they are just great. Is
>> there an equivalent for these HP GPS units?
>>
>> Any suggestions for the operation of these units and your ever expert and
>> kind advise is always welcome. You all have a nice weekend!
>>
>> Kindest regards,
>>
>>
>>
>> Edgardo Molina
>> Dirección IPTEL
>>
>> www.iptel.net.mx
>>
>> T : 55 55 55202444
>> M : 04455 20501854
>>
>> Piensa en Bits SA de CV
>>
>>
>>
>> Información anexa:
>>
>>
>>
>>
>> CONFIDENCIALIDAD DE INFORMACION
>>
>> Este mensaje tiene carácter confidencial. Si usted no es el destinarario
>> de este mensaje, le suplicamos se lo notifique al remitente mediante un
>> correo electrónico y que borre el presente mensaje y sus anexos de su
>> computadora sin retener una copia de los mismos. Queda estrictamente
>> prohibido copiar este mensaje o hacer usode el para cualquier propósito o
>> divulgar su en forma parcial o total su contenido. Gracias.
>>
>>
>> NON-DISCLOSURE OF INFORMATION
>>
>> This email is strictly confidential and may also be privileged. If you are
>> not the intended recipient please immediately advise the sender by replying
>> to this e-mail and then deleting the message and its attachments from your
>> computer without keeping a copy. It is strictly forbidden to copy it or use
>> it for any purpose or disclose its contents to any third party. Thank you.
>>
>>
>>
>>
>>
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to
>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the time-nuts
mailing list