[time-nuts] Stanford RS620 Acting up

[Jürg Kögel]

Use the Sample Size switches

Juerg Koegel

2012/10/16 Eric Haskell <eric_haskell at hotmail.com>:
> Thanks for all the responses.
>
> Well it was even simpler than I expected,  All I had to do was a cold reset followed by an autocal. the unit now will power-up with the display active.  Apparently it was not a hardware error at all.
>
> I now want to calibrate the internal 10 MHz reference.  I read the cal procedure several times. I need to set the value of calbyte 4 (and 50 to minimize offset).  I found and enabled the cal jumper.  I accesses the cal menu.  I displayed and can edit the calbyte 0 but I can't seem to figure out how to navigate to the next calbyte.  How do I select the calbyte to operate on?
>
> Eric Haskell
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.