[time-nuts] Symmetricom 58532A and 58536A group delay figures
John Ackermann N8UR
jra at febo.com
Sun Sep 30 11:59:11 UTC 2012
We measured the delay on a couple of the splitters. I need to dig up the results, but I think the delay is around 7ns in both the 2 and 8 port units, and is pretty consistent port-to-port. I'll find the data and get it on the pages at febo.com.
John
On Sep 30, 2012, at 2:51 AM, Christopher Brown <cbrown at woods.net> wrote:
>
> Assuming it does not snow again, should finish the cabling to the new
> rooftop tripod and switch to the new antenna and splitter tomorrow.
>
>
> For the LMR400 main run and jumpers is simple enough, will just measure.
>
>
> That leaves the antenna and splitter, both have and amp and bandpass
> filter and I am assuming a combined delay that is likely greater than
> the cable delay given the short runs.
>
>
> Nothing is listed in the datasheets, but they are the semi-marketing
> sheets (only a couple pages) rather than a proper datasheet.
>
>
> Anyone know what the delay for this amp and splitter is? Or better yet
> a delay v.s. temp plot?
>
>
> Thanks
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the time-nuts
mailing list