[time-nuts] MS3106R10SL-4S connector question

Bob Stewart bob at evoria.net
Tue Dec 10 13:38:03 EST 2013


Thanks Robert.  So, am I right in thinking that you insert the small end from the connector side of the rubber grommet and pull it through until the thick part just touches the narrowed place in the grommet?  They have it sized to imply that.  Are there any assembly documents on the net that lay it out in a straightforward manner?  I couldn't find anything related to the plastic pin.  Note that this is for future info.  I've assembled my connector with 2 wires and given it my blessing.  =)

Bob




>________________________________
> From: Robert Atkinson <robert8rpi at yahoo.co.uk>
>To: "jfor at quikus.com" <jfor at quikus.com>; Discussion of precise time and frequency measurement <time-nuts at febo.com> 
>Sent: Tuesday, December 10, 2013 12:27 PM
>Subject: Re: [time-nuts] MS3106R10SL-4S connector question
> 
>
>Hi,
>John is correct. The plastic pin is used when a contact position is not wired. You put the unwired pin in first and then insert the plastic pin behind it, thick end first. It replaces the wire to seal that individual hole and also maintain correct seal pressure on the other wires. Blue for #16 pins, Red for #20. Not required if you don't need a full environmental seal. 
>
>Robert G8RPI. CEng, MRAeS, EASA licenced avionics engineer. (i.e. this is a definitive answer, I can certify that one of these is correctly installed on an aircraft :-)
>
>


More information about the time-nuts mailing list