[time-nuts] FE-5680A control programs
Chris Albertson
albertson.chris at gmail.com
Fri May 24 00:22:07 EDT 2013
You have been collecting programs? I did not know there were any to
collect. Do you have a list? I don't have much use for a .exe file but
is your are source codes available that would be great.
On Thu, May 23, 2013 at 4:44 PM, EB4APL <eb4apl at cembreros.jazztel.es> wrote:
> Hello,
>
> Since I bought my FE-5680A (10 MHz, 1 PPS variety), I have been collecting
> control programs for it and keeping then in reserve. Now that I'm going to
> box it with a distribution amp I tried some of them, first of all to adjust
> the frequency against the GPS. I used Bob Campbel's VK4XV
> "Fe5680Calibrator.exe" with good results. I have other programs which
> interrogates the device and shows the hex dumps, but I would like to know
> if there is a windows program that allows to send other that the offset
> related commands to the device and get the responses not in hex but
> translated to plain language. In fact I don't know if there are
> housekeeping commands for reading thinks like the lock status or the lamp
> voltage like the analog outputs of the FRS-C and others.
>
> Thanks in advance,
> Ignacio EB4APL
> ______________________________**_________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/**
> mailman/listinfo/time-nuts<https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts>
> and follow the instructions there.
>
--
Chris Albertson
Redondo Beach, California
More information about the time-nuts
mailing list