[time-nuts] GPS with 10KHz output
Anthony Stirk
upuaut at gmail.com
Fri Sep 20 02:27:17 EDT 2013
Just as a note you can reconfigure the time pulse output any of the Ublox
modules (doesn't have to be the timing module) via commands to give out a
pulse up to :
7 Series :0.25 Hz … 10 MHz
NEO-6G/Q/M/P/V : 0.25 Hz to 1 kHz
NEO-6T :0.25 Hz to 10 MHz
Don't know if this helps anyone.
Cheers,
Anthony
On Fri, Sep 20, 2013 at 3:24 AM, Bill Reed <breed at otelco.net> wrote:
> Hi Merv,
>
> Thanks. I will try one.
>
> This is a great group!
>
> Bill
>
>
> -----Original Message----- From: Merv Thomas
> Sent: Thursday, September 19, 2013 9:01 PM
> To: time-nuts at febo.com
>
> Subject: Re: [time-nuts] GPS with 10KHz output
>
> Hi Bill,
>
> I have a number of these modules purchased from the particular eBay source
> you gave a link for. They work well but I never found a way to keep their
> data output as NMEA as they seem to revert to Binary on power down.
> However
> if it is just the 10KHz output you want from them or their Binary data
> stream they should be fine in my humble opinion. I have a small batch file
> that commands them into NMEA once powered up but nothing to save this
> setting.
>
> Merv VK6BMT
>
> ______________________________**_________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/**
> mailman/listinfo/time-nuts<https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts>
> and follow the instructions there.
> ______________________________**_________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/**
> mailman/listinfo/time-nuts<https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts>
> and follow the instructions there.
>
More information about the time-nuts
mailing list