[time-nuts] Tektronix TM500 extender cable ki
Tom Miller
tmiller11147 at verizon.net
Mon Aug 4 14:34:07 EDT 2014
Mark, that is a nice idea and much easier to construct. Count me in for two
sets.
Regards,
Tom
----- Original Message -----
From: "Mark Sims" <holrum at hotmail.com>
To: <time-nuts at febo.com>
Sent: Monday, August 04, 2014 2:20 PM
Subject: [time-nuts] Tektronix TM500 extender cable ki
>I have seen the Jamma kit (I will be using their edge connectors) and
>John's design. Their main problem is the hassle of wiring up 56
>individual wires. Also that tends to be not all that reliable... wires
>tend to break at the solder joints.
> The board that I laid out has two 40 pin ribbon cable box headers on it
> (the layout is compatible with IDE headers that have pin 20 removed or
> blocked). All of the power pins on the TM500 bus use two conductors (plus
> Tek doubled or quadrupled most of the power pins). The other pins are
> signal level pin that don't carry much current. A single 28 ga ribbon
> wire of the appropriate length should be able to do an amp or so. There
> should not be any major problems running most modules.
> The same board is used on the mainframe side and module side of the cable
> (photo attached).
> A nice thing about the design is you can very easily replace the cables
> with new ones of any desired length.
>
--------------------------------------------------------------------------------
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
More information about the time-nuts
mailing list