[time-nuts] Lucent KS-24361 15 Mhz and 10 Mhz

Bob Camp kb8tq at n1k.org
Mon Dec 1 07:38:16 EST 2014


Hi

If you have a pair of units, then you have a 10 MHz out of the second box. If you want to have everything in one box, (and not run a pair) you need to re-configure the 15 MHz output as a 10 MHz. 

Bob

> On Dec 1, 2014, at 1:40 AM, Dr. David Kirkby (Kirkby Microwave Ltd) <drkirkby at kirkbymicrowave.co.uk> wrote:
> 
> On 1 Dec 2014 03:35, "paul swed" <paulswedb at gmail.com> wrote:
>> 
>> OK so it was not as hard as I thought getting all of teh screws out. The
>> harder part is getting the actual board to slip out of the back.
>> After getting to the bottom I found a locked 10 Mhz signal on U206 pin 1
>> somewhat of a sine wave
> 
> Why do you need to do this?  The picture I see on eBay shows an SMA
> connector with "10 MHz TP" on it. I assumed that was a 10 MHz output, but I
> assume that there's a good reason you are doing this.
> 
> Dave
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.



More information about the time-nuts mailing list