[time-nuts] Lucent KS-24361, curious observation

[Bob Camp]

HI

Wiggle the connectors on the magic cable. If that does not fix the issue, unplug and re-plug it a couple times. Next step would be to replace the cable. 

Bob

> On Dec 1, 2014, at 11:15 AM, Graham <planophore at aei.ca> wrote:
> 
> Good day all,
> 
> I finally have my KS-24361 REF-0 and REF-1 pair powered up and receiving a good GPS signal.
> 
> The REF-1 unit has only the STBY LED flashing but the REF-0 has the STBY flashing, and the GPS, and FAULT LED's on. It has been less than 18 hours since I powered them up so I am not yet wondering why the the REF-0 LED's are in the state they are as I have seen reports of others having to wait 24 hours or so before every "locks in".
> 
> However, this morning before I left the house, I noticed that STBY led's on both units were no longer flashing on and off in near sync. When first powered up they were blinking on and off at about the same time. The blinking is about once per second (simple observation) but one unit is blinking a bit faster (or slower) than the other and they slowly rotate through blinking together to not being together.
> 
> Got me to wondering if when the STBY led's are blinking that it is any indication of that unit's PPS. I have not yet got around to digging into their internals yet but I know some other have.
> 
> cheers, Graham ve3gtc
> 
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.