[time-nuts] Lady Heather and the NTGS50AA
EB4APL
eb4apl at cembreros.jazztel.es
Sat Jan 18 10:01:05 EST 2014
Oops, I meant Mark Sims, sorry.
Ignacio EB4APL
On18/01/2014 15:27, EB4APL wrote:
> I have a NTGS50AA working with the Lady Heather last version which
> incorporate support for this board (Thanks Mask Sims).
> When I bought the board I used the Trimble utility GPS Monitor (GPSTM
> Commissioning Tool V1.5) to set it up and in the way knowing that it
> was previously working in Guatemala. This program uses COM1 or 2
> with a fixed configuration of 19200, 7,Odd and 1stop bit. After using
> LH it seems that it changed the parameters to 9600.0.N,1 probably
> using an undocumented command and the board stores this configuration
> even if unpowered. But now I can't use the Trimble program because
> it refuses to connect, even it crashes when trying to connect at 19200
> baud. Strangely it worked a couple of times when I was trying to
> command the leds in the panel but I don't know how it managed to
> change the baud rate.
> Does anybody know how to change the configuration of the board serial
> port, maybe an undocumented command? I have the manual but I don't
> find anything neither in the LH documentation.
>
> Regards,
> Ignacio
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
More information about the time-nuts
mailing list