[time-nuts] WTB WECO Adapter
W4wj at aol.com
W4wj at aol.com
Thu Jul 10 18:54:23 EDT 2014
TNX for that information Chuck!!
73
Don
W4WJ
In a message dated 7/10/2014 5:29:28 P.M. Central Daylight Time,
cfharris at erols.com writes:
Be warned, that Trompeter makes at least two varieties.
The one you want has the thicker center pin that extends
to within 1/8 inch of the end of the shield. The incorrect
connector has a thinner center pin that only extends to
about 1/4 inch of the end of the shield.
The family number of both the right and the wrong connector
is the same: TEI-14949
The part that specifies the pin is AD1 for the wrong connector,
and AD1W for the right connector...
So the full part number of the connector you desire is:
TEI-1949 AD1W
These are Western Electric (eg. telco) connectors, not the
more common video patch panel connectors.
-Chuck Harris
OBTW, if you have any of the cable mounted WECO connectors,
it is very easy to screw a standard chassis mount BNC connector
where the cable screws in, and make your own adapter.
W4wj at aol.com wrote:
> Stan...
>
> I'll check Trompeter too...
>
> TNX
>
>
> 73
> Don
> W4WJ
>
>
>
> In a message dated 7/10/2014 12:35:45 P.M. Central Daylight Time,
> stanw1le at verizon.net writes:
>
> Consider the Trompeter series of adapters. Stan, W1LE
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the time-nuts
mailing list