[time-nuts] ELEMEK LXK WWVB Receiver

[Tom Holmes]

A good point, David. I just picked it up to play with and thought it would
be helpful to have the manual or a schematic.

I did see that article but it did not have much more information than that
it was for WWVB and the new price was $99!

Thanks for looking.

Tom Holmes, N8ZM

-----Original Message-----
From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
Behalf Of David McGaw
Sent: Tuesday, March 11, 2014 3:44 PM
To: Discussion of precise time and frequency measurement
Subject: Re: [time-nuts] ELEMEK LXK WWVB Receiver

 From an ad in Radio-Electronics June 1980, it mentions that it 
phase-locks to the carrier.  I expect the new format of WWVB will give 
it fits.

https://archive.org/stream/radio_electronics_1980-06/Radio_Electronics_June_
1980#page/n71/mode/2up/search/wwvb

73,

David N1HAC


On 3/11/14 1:55 PM, Tom Holmes wrote:
> Does anyone have any information on this box?
>
>
>
> It has 60 kHz and 100 kHz outputs, runs on 12 VDC. Not much info found on
> the web so far.
>
>
>
> Tom Holmes, N8ZM
>
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.

_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.