[time-nuts] Lucent KS-24361 GPSDO arrived today several questions

Bob Camp kb8tq at n1k.org
Fri Nov 7 18:10:32 EST 2014


Hi

There was a post from Goetz Romahn about a new version of Z38XX that will work correctly with the 3810/11/12. The previous version worked fine under XP. It’s a far better program to use than SatStat.

Bob


> On Nov 7, 2014, at 3:48 PM, GandalfG8--- via time-nuts <time-nuts at febo.com> wrote:
> 
> Which one are you using?
> 
> The bottom one referred to on Didier's site is the old Windows 3 version,  
> perhaps even DOS, going back to 1993 or thereabouts.
> 
> The later version is the one marked Satstat50, actually SatStat 5.0 and a  
> Symmetricom release from 2001.
> 
> I can't try it on Win7 right now but did think I'd had it running  
> previously.
> 
> Regards
> 
> Nigel
> GM8PZR
> 
> 
> In a message dated 07/11/2014 20:42:26 GMT Standard Time,  
> xaos at darksmile.net writes:
> 
> It seems  that this program will not work for Win 7.
> Has anyone attempted to  decompile this thing?
> 
> Maybe re-work a bit and have it run on  anything?
> -George, N2FGX
> 
> On 11/07/2014 01:34 PM, Bob Stewart  wrote:
>> Hi Bill,
>> 
>> I think I got my copy here.  I  used the bottom one.  I don't know what a 
> 58503 is.  it was hard to  find, for some reason.  I'm using XP on an old 
> laptop.
>> 
>> http://www.ko4bb.com/manuals/index.php?dir=05%29_GPS_Timing/SatStat
>> Bob
>>      From: Bill Riches  <bill.riches at verizon.net>
>> To: 'Bob Stewart'  <bob at evoria.net>; 'Discussion of precise time and 
> frequency measurement'  <time-nuts at febo.com> 
>> Sent: Friday, November 7, 2014 7:04  AM
>> Subject: RE: [time-nuts] Lucent KS-24361 GPSDO arrived today  several 
> questions
>> 
>> Hi Bob and  group,
>> 
>> Where are you obtaining Satstat and what windoze  version will it work 
> on?  XP, W7 32 or 64 bit?  XP I  guess?
>> 
>> Bill Riches
>> Cape  May
>> 
>> 
>> 
>> -----Original Message-----
>> From:  time-nuts [mailto:time-nuts-bounces at febo.com] On Behalf Of Bob 
> Stewart
>> Sent: Friday, November 07, 2014 12:03 AM
>> To: Discussion of precise  time and frequency measurement
>> Subject: Re: [time-nuts] Lucent  KS-24361 GPSDO arrived today several 
> questions
>> 
>> Hi Bob,
>> I've been using the Satstat program to send commands.  What I don't  
> understand is why the slave will accept commands such as sat elevation angle  
> and not give an error response.  It gives a response of "command  complete", 
> but it doesn't change it.  Or is that an indication that both  units use the 
> same firmware, and success is actually indicated by the  resulting change 
> of the angle?
>> 
>> Bob    From: Bob Camp  <kb8tq at n1k.org>
>> To: GandalfG8 at aol.com; Discussion of  precise time and frequency 
> measurement  <time-nuts at febo.com>
>> Sent: Thursday, November 6, 2014 6:07  PM
>> Subject: Re: [time-nuts] Lucent KS-24361 GPSDO arrived today  several 
> questions
>> 
>> 
>> ---
>> This email is free from  viruses and malware because avast! Antivirus 
> protection is active.
>> http://www.avast.com
>> 
>> 
>> 
>> _______________________________________________
>> time-nuts mailing list  -- time-nuts at febo.com
>> To unsubscribe, go to  
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the  instructions  there.
> 
> _______________________________________________
> time-nuts  mailing list -- time-nuts at febo.com
> To unsubscribe, go to  
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the  instructions there.
> 
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.



More information about the time-nuts mailing list