[time-nuts] Lucent KS-24361 24V DC power requirements

Graham planophore at aei.ca
Sat Nov 22 09:43:27 EST 2014


Thank you all for the answer to my query.

cheers, Graham ve3gtc

On 2014-11-21 21:17, Bob Camp wrote:
> Hi
>
> We’ve been around this one before. The KS boxes are powered by a switcher brick inside the box. There’s not a lot of reason go super crazy on the DC input. It’s fully isolated from the case ground. Even leakage / stray grounds should not be an issue in this situation. I would not run it off of raw un-filtered rectifier output. Anything that’s at least got a filter capacitor in it should do fine.
>
> Bob
>
>> On Nov 21, 2014, at 3:19 PM, Neil Schroeder <gigneil at gmail.com> wrote:
>>
>> I drive my prs10 with a parallel pair of ldos balanced by an op amp. I'll
>> draw it out and post it if you like.
>>
>> On Friday, November 21, 2014, Azelio Boriani <azelio.boriani at gmail.com>
>> wrote:
>>
>>> At most you need 2.4A (when the two OCXOs are heating up): a 2.5A
>>> supply is needed.
>>>
>>>



More information about the time-nuts mailing list