[time-nuts] What sort of oscillator is this?

[Dr. David Kirkby (Kirkby Microwave Ltd)]

On 29 September 2014 22:45, Bob Camp <kb8tq at n1k.org> wrote:
> Hi
>
> The information came from the HP data sheet on the oscillator. They provide it to the people who manufacture the oscillators for them.
>
> Bob


Can you share the data sheet?

Dave

> On Sep 29, 2014, at 1:14 PM, Dr. David Kirkby (Kirkby Microwave Ltd) <drkirkby at kirkbymicrowave.co.uk> wrote:
>
>> On 29 Sep 2014 17:58, "Bob Raker" <bob.raker at gmail.com> wrote:
>>>
>>> It is a low end OCXO - uses AT cut crystal.  15V @ 300 mA.  Warm-up time
>> is
>>> 6 minutes max for .1 ppm.  Other specs as indicated in previous emails.
>>>
>>> Has NO EFC.
>>
>> Where do you get this information from?
>>
>> I think I am going to take the covers off this soon, as I am keen to get
>> direct access to the samplers.  Unfortunately Keysight have now sold all
>> the cables, but do have the front panel overlay which is arguably the most
>> critical item. When I do, I will photograph the oscillator.
>>
>> Dave
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.