[time-nuts] homebrew counter new board test result

[Magnus Danielson]

Dear Li Ang,

Nice to have you back reporting on your progress!

Now, you have some pretty impressive performance going on there. Looks 
like a nice little unit too.

Is the C-channel the SMA on the back of the PCB?

How did you wire up the 74LVC2G14?

While it is tempting to use both channels in it, don't if you want to 
keep cross-talk between channels low.

Cheers,
Magnus

On 02/23/2015 02:10 PM, Li Ang wrote:
> Hi,
>     I'm back. I have been testing my new borad for days.
>     Compared to previous version, this board makes the PCB track of signals far from each other and replaces LDO for TDC with LP5907.
>     CH_A: simple resistor bias and ac couple "front end", CH_B: CH_A+MC100LVELT22 LVPECL , CH_C: CH_A+74LVC2G14 .
>     At first, the result is worse than previous board. Using CH_B as the REF and DUT source, the stdev of the phase measurement is about 160ps. The old board can reach about 70ps. CH_A and CH_C are way much better than CH_B. That bothers me for days.
>     Today, I use the 74LVC2G14 to square the signal from MV89A, and do the same test. For all three channel, the stdevs are about 37ps. The spec of TDC_GP22 is 35ps. And now the performance looks a little bit better than the previous board.  It looks like that the jitter of MC100LVELT22 is much bigger at slow slew rate.
>     It seems that next step is to play with the front end.
>
>
> The raw data is uploaded to http://www.qsl.net/b/bi7lnq/freqcntv4.1/test/20150222/
> The pic of this version is uploaded to http://www.qsl.net/b/bi7lnq/freqcntv4.1/pic/ ‍
>
>
>
>
> Regards
> Li Ang
>
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>