[time-nuts] 10MHz Square to Sine Wave Conversion

Chris Albertson albertson.chris at gmail.com
Thu Jul 16 22:43:07 EDT 2015


How good does the sine wave need to be?   The usual method is to use a
low-pass filter  A CLC "pi" filter works.

On Thu, Jul 16, 2015 at 10:49 AM, skipp Isaham via time-nuts
<time-nuts at febo.com> wrote:
> re: 10MHz Square to Sine Wave Conversion
>
> The GPSDO I recently acquired outputs a 10 MHz square wave. I'd like
> to convert it to a sine wave and I am looking for suggestions and info re
> any reasonable pre-made circuits and/or boards. No sense reinventing the
> wheel if I can avoid it.
>
> Otherwise I will start from scratch and make a new wheel....
>
> Thank you in advance for your replies.
>
> Regards,
>
> skipp
>
> skipp025 at yahoo dot com
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.



-- 

Chris Albertson
Redondo Beach, California


More information about the time-nuts mailing list