[time-nuts] Acquired a Symmetricom 5817A-05Q / Power connector Question

[paul swed]

Hello to the group I would agree its coax. But also the n connector to the
right can take DC in and power the splitter. So if your rcvr puts out
4.5-30V you are in business. I say this from the internal pix you posted of
the unit. That was very helpful.
Regards
Paul
WB8TSL

On Sat, May 9, 2015 at 3:15 AM, Hal Murray <hmurray at megapathdsl.net> wrote:

>
> m.matthew.george at gmail.com said:
> > Anyway, I'm not too proud to admit that I'm not familiar with the power
> > connector that apparently comes with the 05Q option.  I have a link
> below to
> > a couple of pictures.   Maybe I missed something obvious when poking
> around
> > on the internet for documentation, but I can't find anything that
> describes
> > this connector.  I assume it is stock?  The +DC input pin/wire can be
> seen
> > just inside the white tube... again, maybe this is obvious to real
> > time-nuts!  I'm working on that time-nut thing!
>
> The white tube looks like insulation from coax.  Have you tried taking the
> connector apart?
>
> You might poke around with an ohmmeter.  It looks close to setup to take
> power from the lower right output connector.  Adding a few parts may switch
> it back to that mode.
>
>
> --
> These are my opinions.  I hate spam.
>
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>