[time-nuts] python or matlab/octave for Keysight instruments?

[Bob Camp]

Hi


> On Jul 2, 2016, at 1:58 PM, Hal Murray <hmurray at megapathdsl.net> wrote:
> 
> 
> jimlux at earthlink.net said:
>> I'm fine with writing the SCPI commands and parsing the output, I'm just
>> looking for the "glue" between "send_message_to_instrument" or
>> "read_message_from_instrument" and the instrument itself. 
> 
> Why do you need any glue?  What type of device is it?  Why not just open it 
> and read/write?
> 
> That's what I did with a Rigor

Hopefully a Rigol scope ….Isn’t spell check / auto correct fun ? 

Bob

> scope.  I have a udev rule so it shows up as 
> /dev/scope no matter where I plug it in:
> KERNEL=="usbtmc*", ATTRS{serial}=="DS1EB132703507",  MODE="0666", 
> SYMLINK+="scope"
> 
> 
> -- 
> These are my opinions.  I hate spam.
> 
> 
> 
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.