[time-nuts] Swagelok and metric tubing question

Scott McGrath scmcgrath at gmail.com
Fri Nov 11 14:34:07 EST 2016


Hi Corby

Is there a requirement for a specific alloy?   I might have some odds and ends lying around 

Content by Scott
Typos by Siri

> On Nov 11, 2016, at 12:51 PM, <cdelect at juno.com> <cdelect at juno.com> wrote:
> 
> This sound off topic but it's for a Hydrogen Maser modification!
> The EFOS2 Maser is running low on Hydrogen and this time rather than
> refill the compressed gas bottle I'd like to install a Hydrostik in its
> place.
> I have obtained all the fittings I need but have hit a snag!
> I need a few short pieces of 10mm OD 1 or 2mm  wall stainless tubing to
> go into the Metric Swagelok fitting.
> However all I can find on the net would cost me over $100.00!
> Does anybody have a few short lengths (two 3" and two 4" if cut ready to
> insert in the fitting) or one 18" piece that I could buy at a reasonable
> price???
> 
> Thanks,
> 
> Corby
> 
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.


More information about the time-nuts mailing list