[time-nuts] Machining some aluminum help!
Scott McGrath
scmcgrath at gmail.com
Thu May 18 17:22:07 EDT 2017
Content by Scott
Typos by Siri
> On May 18, 2017, at 4:34 PM, <cdelect at juno.com> <cdelect at juno.com> wrote:
>
> Well that generated a lot of advice and thanks for it!
> I think I might do it myself and go with a 1/2" hole depth and 1/4"
> threaded depth.
> I'll get some of that Aluminum Tap magic, some new taps and new drill
> bits.
> Good idea about drilling the end plates first and drilling thru to match.
> Between the end plate and the tube is a gasket that needs to seal
> pressure and moisture tight. That's why I used 5 per side.
>
> Will let you know how it turns out.
>
> Cheers,
>
> Corby
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the time-nuts
mailing list