[time-nuts] OCXO Vectron 218Y44442

[Mark Spencer]

I've experienced this with products with simple crystal oscillators.   (Ie. Tap or bang the unit to get the oscillator to start oscillating.)

Mark Spencer

mark at alignedsolutions.com
604 762 4099

> On Oct 16, 2017, at 1:10 PM, Vlad <time at patoka.org> wrote:
> 
> 
> Hello,
> 
> I am wandering if anybody observe the behavior for OCXO, when its stop to reproduce the signal, and the only way to return it back to business is little mechanical stress.
> 
> I have TWO of such OCXO. One of them is Austron 11.2 Mhz. And another one is Vectron model 218Y4442 9.8304Mhz
> 
> In case with Vectron, I even disassemble it (to whom who brave here is a pictures):
> 
> http://www.patoka.ca/Vectron-218Y44442/
> 
> Then as I connect it to the PS, I realize it start to reproduce the signal again ! Before this it was nothing ! I tried different PS before to open this "can" as a last resort.
> 
> For the Austron - I didn't disassemble it. Instead I just kick it a little bit. And immediately after that, it start to produce the signal !
> 
> 
> -- 
> WBW,
> 
> V.P.
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>