[time-nuts] OCXO Vectron 218Y44442
azelio.boriani at gmail.com
Tue Oct 17 02:18:10 EDT 2017
The crystal is socketed: the problem might be the socket.
On Tue, Oct 17, 2017 at 1:56 AM, Bob kb8tq <kb8tq at n1k.org> wrote:
> Welcome to the 1990’s … that’s an *old* design. Since Vectron kept building same / same
> (if you ordered it that way) who knows when it was built.
>> On Oct 16, 2017, at 4:10 PM, Vlad <time at patoka.org> wrote:
>> I am wandering if anybody observe the behavior for OCXO, when its stop to reproduce the signal, and the only way to return it back to business is little mechanical stress.
>> I have TWO of such OCXO. One of them is Austron 11.2 Mhz. And another one is Vectron model 218Y4442 9.8304Mhz
>> In case with Vectron, I even disassemble it (to whom who brave here is a pictures):
>> Then as I connect it to the PS, I realize it start to reproduce the signal again ! Before this it was nothing ! I tried different PS before to open this "can" as a last resort.
>> For the Austron - I didn't disassemble it. Instead I just kick it a little bit. And immediately after that, it start to produce the signal !
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the time-nuts