[time-nuts] Furuno GT-8031 breakout board
Didier Juges
shalimr9 at gmail.com
Mon Feb 19 18:28:07 EST 2018
What do you mean by “Adafruit” pinout?
On Fri, Feb 16, 2018 at 11:50 AM Mark Sims <holrum at hotmail.com> wrote:
> No, the Tbolt does not have a separate receiver board... plus its' GPS is
> rather special... the RF chain is locked to the OCXO so it does not produce
> any sawtooth error.
>
> The Lucent KS firmware expects the GPS to support the older 6/8 channel
> messages. The newer 12 channel messages are different.
>
> BTW, I just did a Motorola M12 to Adafruit pinout board. The M12 form
> factor and pinouts are also used by a lot of other timing receivers. Why
> Adafruit? Because it is breadboard friendly, has enough pins for all the
> signals that one expects, and my GPS to RS-232 adapter board has an
> Adafruit connector on it.
>
> ----------------
>
> > Never having opened my TBolt, are the GT-8736 boards of use to replace
> the aging and partly deaf receiver in that? Or for a KS-24019?
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
More information about the time-nuts
mailing list