[time-nuts] Furuno GT-8031 breakout board
Didier Juges
shalimr9 at gmail.com
Mon Feb 19 18:28:57 EST 2018
Got the answer in the previous email :)
On Mon, Feb 19, 2018 at 5:28 PM Didier Juges <shalimr9 at gmail.com> wrote:
> What do you mean by “Adafruit” pinout?
>
> On Fri, Feb 16, 2018 at 11:50 AM Mark Sims <holrum at hotmail.com> wrote:
>
>> No, the Tbolt does not have a separate receiver board... plus its' GPS is
>> rather special... the RF chain is locked to the OCXO so it does not produce
>> any sawtooth error.
>>
>> The Lucent KS firmware expects the GPS to support the older 6/8 channel
>> messages. The newer 12 channel messages are different.
>>
>> BTW, I just did a Motorola M12 to Adafruit pinout board. The M12 form
>> factor and pinouts are also used by a lot of other timing receivers. Why
>> Adafruit? Because it is breadboard friendly, has enough pins for all the
>> signals that one expects, and my GPS to RS-232 adapter board has an
>> Adafruit connector on it.
>>
>> ----------------
>>
>> > Never having opened my TBolt, are the GT-8736 boards of use to replace
>> the aging and partly deaf receiver in that? Or for a KS-24019?
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to
>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>>
>
More information about the time-nuts
mailing list