[time-nuts] newbie question Thunderbolt supply

Edgardo Molina xe1xus at amsat.org
Sat Aug 25 22:41:09 UTC 2012

Dear Chris,

Good afternoon. I am in the process of mounting my TBolt to a 2U 19" rack enclosure and was looking for a decent power supply. I found the Cisco unit and I am ordering a couple of them just in case. It would really be nice if I could have access to the diagram of the upgrade you did on yours to recreate the same performance from the Cisco unit. Please do not feel compromised if it is difficult to share. I didn't mean to be rude and if my note causes you any discomfort please kindly disregard it. I jumped into the thread because of experiencing the same doubts as the originator of it. 

Redondo Beach? I love visiting there whenever visiting my brother who lives in Rancho Palos Verdes. I would invite you lunch anytime just for the pleasure of meeting you in person.

Thank you.


Edgardo Molina
Dirección IPTEL


T : 55 55 55202444
M : 04455 20501854

Piensa en Bits SA de CV

Información anexa:


Este mensaje tiene carácter confidencial. Si usted no es el destinarario de este mensaje, le suplicamos se lo notifique al remitente mediante un correo electrónico y que borre el presente mensaje y sus anexos de su computadora sin retener una copia de los mismos. Queda estrictamente prohibido copiar este mensaje o hacer usode el para cualquier propósito o divulgar su en forma parcial o total su contenido. Gracias.


This email is strictly confidential and may also be privileged. If you are not the intended recipient please immediately advise the sender by replying to this e-mail and then deleting the message and its attachments from your computer without keeping a copy. It is strictly forbidden to copy it or use it for any purpose or disclose its contents to any third party. Thank you.

On Aug 25, 2012, at 3:26 PM, Chris Albertson <albertson.chris at gmail.com> wrote:

> On Sat, Aug 25, 2012 at 1:06 PM, Jerry <jsternmd at att.net> wrote:
>> I am using a Cisco supply 3 voltage supply for the T-bolt.  Is there any
>> performance loss if the +12vdc rail and the -12vdc rail are off by a few %
>> in opposite directions, e,g  +11.7 vdc and -12.3vdc ?
>> The true nuts here on the time nuts list will tell you that the noise from
> a switching power supply is bad and that you need a regulated linear power
> supply.   But for most practical purposes the Cisco supply is a good one.
> Being only slightly nuts myself.  I use the Cisco   supply but I built a
> small power adaptor board with matching connectors and some "pi" filters
> made with RF choke and capacitors.  I realy don't thing the filters are
> needed but I wanted a connectorized installation and a small choke was as
> easy to solder in as a length of wire.
> -- 
> Chris Albertson
> Redondo Beach, California
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.

More information about the Time-nuts_lists.febo.com mailing list