[time-nuts] Datum Lamp Voltage

paul swed paulswedb at gmail.com
Tue Aug 28 01:44:43 UTC 2012

John only indirectly from other RBs and they are FRS's. They start off
higher 8-11 or so volts then come down to a lower value and sit there for a
long time. I would think you are mid to early life. More towards the mid.
But thats good for quite a few years.


On Mon, Aug 27, 2012 at 9:33 PM, J. Forster <jfor at quikus.com> wrote:

> Hi,
> I'm just powering a new to me Datum Rb, Type 102500-001, LPRO for the
> first time. The unit locks up quickly, and after about an hour, I checked
> the Lamp voltage.
> My unit is sitting at 6.9 VDC.
> From the manual on Didier's site, below 3.0 or over 14 indicate failure.
> Does anyone know whether the measured voltage should be for a new unit?
> I'm trying to guestimat the remaining life.
> Thanks,
> -John
> ============
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.

More information about the Time-nuts_lists.febo.com mailing list