[time-nuts] Symmetricom 1111C OCXO question
azelio.boriani at screen.it
Thu Apr 3 16:25:26 UTC 2014
Other idea than leaving the 6K8 resistor?
On Thu, Apr 3, 2014 at 5:08 PM, Javier Herrero <jherrero at hvsistemas.es>wrote:
> Hello all,
> I've a 1111C OCXO (inside a Symmetricom 5045A that is inside an
> Oscilloquartz OSA 5585) that refuses to start. It seems that one voltage
> regulator is not operating, with only 2V at its output while it should have
> (I think...) around 12V. I've partially analyzed the circuit, and it is
> nothing from other world: a 6.9V reference diode, driving an operational
> amplifier, driving a NPN transistor. But the 6.9V reference diode is biased
> from the regulator output, so... if the regulator does not provide output,
> the zener is not biased, and then... the regulator does not provide output.
> So it must be some kind of start-up circuit, that makes the transistor to
> conduct a bit, or to bias the diode, when power is applied.
> I've been looking around, but not found it yet. I have make a quick test
> by placing a 6k8 resistor between the collector and the base of the
> transistor to make it conduct, and then the regulator starts, provides
> adequate output (12.5V), and also the 5MHz output appears.
> Any idea is welcome :)
> Best regards,
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com