[time-nuts] Is this ocxo salvageable?
mcquate at sonic.net
Wed Apr 9 06:58:55 UTC 2014
The output looks differentiated, as would happen if the wire connecting
the internal circuit to the output pin became open, leaving only a very
small capacitance to couple the square wave out.
On 4/8/2014 11:46 PM, Chris Albertson wrote:
> My Bliley square wave 10MHz OCXO was working just fine for close to 30
> hours until a few hours ago. Now it puts out a rather noisy waveform about
> one volt peak to peak.
> Two questions:
> (1) Are these things repairable, the metal can is soldered.
> (2) As you can see in the attached oscilloscope photo the OCXO still puts
> out a strong 10MHZ component. What is the best way to filter this and
> recover a good 10MHZ square wave?
> In the linked photo, both channels are set to 1 volt per division. The
> large sine wave is from a Trimble Thunderbolt and the smaller wave is from
> the failed ocxo The EFC is left open (disconnected) and a you can see the
> frequency is spot on 10MHz.
More information about the Time-nuts_lists.febo.com