[time-nuts] Yet another Arduino-based GPSDO
albertson.chris at gmail.com
Sat Apr 12 02:59:12 UTC 2014
On Thu, Apr 10, 2014 at 6:42 AM, Jim Harman <j99harman at gmail.com> wrote:
> I have not tried the dual PWM-based DAC, but my concern is that depending
> on the ratio of the resistors it might not be monotonic as the output goes
> from say 0FF to 100 hex. You would see this problem in the output every 256
> counts. Unless there is significant dither in the DAC values, this could
> cause the system to get stuck as it tries to track a slow change in the
> oscillator. The nominal resistor ratio is 255:1. I think it would be best
> to choose the resistors (including tolerance) so that the big one is sure
> to be more than 255x the smaller one. This would cause a jump rather than a
> kink in the output as the DAC varies. Lars uses 39k and 10 megs, which does
> not quite meet this criterion.
My plan was to eventually fix this in software. Using ultra precision
resisters is not a good fix. I'm using normal 5% 1/4W resisters.
I don't think I will get stuck. if a step is to small it will simply move
up the next DAC value. The I term in the PID controller will basically see
that the current DAC setting is not enough can add more. I is (error *
time) and given enough time it will push the DAC in the right direction
even if the error is very small.
I don't have a good way to test the DAC. My Fluke DMM can't see any
problems. But eventually I want to add a self test or self calibration
function. I figure that the OCXO should be a very good voltage meter.
> On the integrator, I am using Lars' circuit with a TDK C0G ceramic
> capacitor FK28C0G1H102J, which is supposed to be good to 30ppm/deg C, and
> no-name carbon resistors. I will fiddle with it and see if I can figure out
> where the sensitivity is coming from.
> On Wed, Apr 9, 2014 at 10:20 PM, Chris Albertson
> <albertson.chris at gmail.com>wrote:
> > But the cheap 16-bit Lars used is
> > working very well. PWM works because we only need less then 1Hz
> > bandwidth so we can filter the heck out of it. The steps are less
> > than I can measure
> > What TIC capacitor did you use. If it is that temperer sensitive you
> > might want to replace it.
> --Jim Harman
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> and follow the instructions there.
Redondo Beach, California
More information about the Time-nuts_lists.febo.com